SPT SP-3618 User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 8
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
1110
Adding Water Dry Boil
Cleaning and Maintenance
Standby Mode
Storage
Add water when water level
falls within the red section on
the Water Level Indicator.
Unit will automatically begin
to boil after adding water. If
not, press the Reboil button.
Unit will automatically enter Standby mode if no buttons are pressed
for 48 hours:
• 208°F Indicator light will flash at a slower rate.
• Press any button to exit unit from Standby Mode.
(If water temp had fallen below set temp, unit will begin to boil.)
1. Unplug from power source. 3. Dump out water.
2. Remove lid. 4. Re-install lid.
To prevent possible scalding, wait for unit to cool down before
removing lid and emptying water.
If water is not used for couple days, the taste may change.
Dump out old water and add fresh water.
For your safety, remove lid before emptying water.
Empty water through the rear corners, as illustrated above.
All indicator light will go
out when power is
disconnected.
If there is no water or
if water level is low,
Dry boil indicator
will flash and unit
will beep 12 times.
Add water
immediately.
Press Reboil button
to begin boiling.
Unplug unit from power source.
Do not wash under running water, as it may wet the control
panel or power receptacle and cause unit to malfunction.
Do not immerse unit in water or any other liquid.
Do not spray water onto the control panel.
Do not use bleach, alcohol or other chemicals.
Do not scrub with metal pads or sharp objects.
Wash filter frequently to prevent blockage.
After cleaning filter, ensure it’s securely re-attached.
Minerals in tap water may cause white residues to attach to the
inner tank or sometimes change the tank’s color reddish or black..
Clean the interior frequently to avoid this problem.
If unit is in Dry-boil for over a period of time – it will cause
the inner tank to change color (due to temperature). This
color change cannot be reversed.
Page view 5
1 2 3 4 5 6 7 8

Comments to this Manuals

No comments