98
Temperature Setting
Re-Boil
Dispensing Water
Boil to Keep Warm
5 temperature settings: 208°F,
194 °F, 176 °F, 140 °F, and Cool.
To set/change temperature
• Press the TEMP SET button until
the indicator light for the desired
temperature flashes.
• Once water boils, unit will
maintain water at set temperature.
Indicator light will stay lit.
• Cool Setting: unit will boil water
then stop heating. Pressing the Re-
boil button will reboil water.
• If temp setting is changed from
lower to higher setting, unit will
begin to re-boil.
• If temp setting is changed from
higher to lower, unit will stop
heating and allow water temp to
drop to new setting.
Default temp setting is
208°F. If power is
disconnected, unit
returns to default
setting after power is
reconnected.
Panel indications from boiling to keep warm at set temp.
(Below is example of temperature setting at 194°F.)
Boiling Process
• Boil indicator light is lit.
• Set temp indicator light blinks.
Water Boiled
• Unit beeps 9 times.
• Boil indicator light goes off.
• Set temp indicator light blinks.
Keep Warm
• Set temp indicator stops blinking.
Note: After water boils, set temp
indicator will continue to blink
until water temperature drops down
to set temp. Indicator light then
stops blinking and stays lit.
• Do not open lid during the
boiling process or
immediately after. Hot water or
vapors may cause scalding.
• Do not touch the steam outlet.
To reboil water, press the REBOIL button. Unit will beep and
Boil indicator will lit.
•If water temp is 203°F or higher, unit will boil for 3 minutes.
•If water temp is below 203°F, unit will bring water back to
boiling point.
1. Press UNLOCK
button.
2. Place cup under
water outlet and
press DISPENSE
button.
3. Press UNLOCK
button again to
lock dispense.
Unit beeps. Unlock
indicator light comes
on.
When DISPENSE
button is pressed,
light will come on.
Unit beeps. Light
and unlock indicator
light goes off.
• Water cannot be dispensed when unit is locked and when
power is disconnected.
• If water is not dispensing smoothing, the interior may be dirty.
Clean unit according to directions on page 12.
• If UNLOCK button is not pressed after dispensing water, unit
will automatically lock dispense after 15 seconds.
• Do not rotate or move the unit while dispensing.
(8 pages)
(5 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals