16
OPERATING INSTRUCTIONS - WATER DRAINAGE
Fig.31
Fig.32
Air lter
(install)
Air lter
(take out)
17
CARE AND MAINTENANCE
Emptying the Water Tank
When the water in the bottom tray reaches its maximum capacity, the unit will beep 8 times
and display will show “P1”. At this time, the compressor will immediately stop (Cool/Dry modes)
but fan will continue to operate.
1. Place a collection pan underneath the bottom drain spout or carefully move the unit to a
drain location.
2. Remove the drain plug and water will begin to drain out.
3. Replace the drain plug and restart the unit. P1 indicator should disappear.
Note: Be sure to replace the drain plug before restarting the unit.
Continuous Drainage (optional)
For COOL/DRY modes:
1. Remove the plug from Continuous Drain Outlet.
2. Connect a 3/4” hose (not included).
3. Place the open end of the hose directly over drain
area or bucket.
Note: Make sure connections are secure to prevent
leakage. Make sure there are no kinks that may stop
the water ow.
IMPORTANT:
- Be sure unit is off and unplugged before cleaning or servicing.
- Do not use gasoline, thinner or other chemicals to clean.
- Do not wash the unit directly under a tap or spray with
water hose. May cause electrical danger.
- If the power cord is damaged, it should be repaired by
manufacturer or certied electrician.
Air Filters
Clean the lters at least once every two weeks to prevent
inferior fan operation due to dust accumulation.
1. Remove lter according to arrow direction in Fig 31.
2. Wash the air lter by immersing gently in warm water
(about 104°F) with a neutral detergent. Rinse the lters
and allow to dry completely in a shady area - do not
place under direct sunlight.
3. Replace lter according to arrow direction in Fig 32.
Note: The grill and air lter are connected and can be
separated.
Housing
Use a lint-free cloth soaked with neutral detergent to clean
the unit’s housing. Finished by a dry clean cloth.
Storage
1. Remove the rubber plug at the Continuous Drain Outlet
and attach hose to drain out water (refer to page 16).
2. Remove the plug from the bottom drain outlet and allow
water to drain (refer to page 16).
3. Run the unit in FAN mode for half a day in a warm room.
This will dry the inside of the unit and prevent mold and
mildew growth.
4. Power off the unit and unplug from power source. Wrap
the cord and bundle it with tape.
5. Clean the air lters and reinstall.
6. Remove the batteries from the remote controller.
7. Cover with a plastic bag and store in a cool, dry place.
Fig.28
Fig.29
Fig.30
(1 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals