SPT SF-16W81 Owner's Manual download pdf (Page 3)

1. Unscrew the spinner clockwise (this part may be packed separately in bag)

and unscrew plastic nut counterclockwise to remove. Fix the rear grill onto the

motor shaft, replace plastic nut and turn clockwise to tighten. (Fig.1)

2. Insert the blade onto shaft - make sure the rotor shaft pin is tted into the groove

on the blade. Turn the spinner counterclockwise to tighten the blade. (Fig.2)

3. Fix the front grill to the rear grill with then use the fasten clip with locking screw to

secure the front grill. (Fig.3)

GRILL & FAN BLADE ASSEMBLY

Fig.1 Fig.2 Fig.3

MOUNTING ON THE WALL

Fan should be installed on solid wood or a pillar which stands

vertically to oor.

CAUTION: To prevent the fan from falling off, DO NOT install

it on walls less then 4 inches thick or made of materials that

are easily damaged.

1. Installing the mounting bracket.

Fix the supplied mounting bracket to the wall using

the two screws. Be sure bracket is rmly in place.

NOTE: The bracket should be placed at least 12

inches below the ceiling and at least 12 inches

from adjoining wall.

2. Installing the fan.

Mount the fan onto the bracket by inserting the bracket

catch into the open slot on.

REMOTE CONTROLL (Fig.4)

OPERATING INSTRUCTION

“ ” ON/OFF KEY

Press to turn on and press again to turn fan off.

“ ” TIMER KEY

Press to set timer: 30 minutes, 1H, 2H and 4H. The corresponding

time indicator will illuminate.

When none of the timer indicators are lit, the unit runs continuously.

Fig 4

1 2 3 4 5 6

No comments

SPT SF-16W81 Owner's Manual Page 3